Is the 2.4 inch SPI TFT touch display the right size for my project?
For most student projects, yes. The 2.4 inch SPI TFT touch display gives you a 320×240 QVGA screen with a resistive touch panel, and the module measures about 72mm × 52mm × 7mm. That fits neatly into handheld devices, control panels and instrument cases.
- Smaller text displays: if you only need a few lines of text, a 16×2 LCD Display with I2C Module is simpler and cheaper.
- Compact graphic displays: for tiny dashboards and wearables, look at the 0.96 Inch 128×64 I2C OLED Display Module or the 1.3 Inch 128×64 OLED Display Module.
- Touch and colour: when you need buttons on screen, graphs or images, this 2.4 inch module is the practical choice.
Check the space around your mounting holes and leave room for the ribbon and header pins before you cut an enclosure.
How do I connect and set up the 2.4 inch SPI TFT touch display?
You wire it over the 4-wire SPI bus and load a matching library. The module runs on 3.3V to 5V, so it works directly with Arduino, ESP32, STM32 and Raspberry Pi boards.
- Connect VCC, GND, and the SPI lines (SCK, MOSI, MISO, CS, DC, RST) to your board.
- Connect the touch pins for the XPT2046 touch controller.
- Install Adafruit_GFX, TFT_eSPI or MCUFRIEND_kbv and set the pins in the library config.
- Run a test sketch to confirm the display and touch both respond.
If the screen stays white, check the backlight pin and the logic level first. The white LED backlight and 65K colour output are driven from the same supply, so a loose ground shows up as a blank screen. The module is listed at Rs. 1,500, checked in September 2026. College Road Electronics delivers across Pakistan at a flat rate of Rs 350, and students can get guidance on wiring and libraries for their projects.
Frequently Asked Questions
What driver IC does this 2.4 inch SPI TFT touch display use?
The module uses the ILI9341 display driver, with the ST7789 also listed in the product details. Touch is handled by the XPT2046 resistive touch controller. Both are supported by common Arduino libraries such as Adafruit_GFX, TFT_eSPI and MCUFRIEND_kbv, so setup is straightforward.
Can I use this display with an ESP32 or Raspberry Pi?
Yes. The 4-wire SPI interface and 3.3V to 5V operating voltage make it compatible with Arduino, ESP32, STM32 and Raspberry Pi boards. On the Pi you use the SPI bus and a Python or C library that supports the ILI9341 driver.
Is the touch panel capacitive or resistive?
It is a 4-wire resistive touch panel. Resistive touch works with a finger, stylus or any pointed object, which suits control panels and instrument interfaces. If you specifically need a capacitive touch screen, this module is not the right fit.
How much does the 2.4 inch SPI TFT touch display cost in Pakistan?
The module is listed at Rs. 1,500, checked in September 2026. College Road Electronics is based on College Road, Rawalpindi and delivers nationwide across Pakistan at a flat shipping rate of Rs 350.
What projects can I build with this 320×240 TFT display?
Common uses include touchscreen control panels, IoT monitoring dashboards, smart home interfaces, embedded system displays, portable instrumentation and educational projects. The 320×240 resolution and 65K colour depth handle text, graphs, icons and simple images well.













Reviews
There are no reviews yet