2.8 Inch SPI TFT Non-Touch Display Screen Module (240×320)

2.8 Inch SPI TFT Non-Touch Display Screen Module (240×320)

The 2.8 Inch SPI TFT Non-Touch Display Screen Module (240×320) is a compact, high-resolution full-color display built around the ILI9341 display controller. Designed for Arduino, ESP32, Raspberry Pi and other microcontroller platforms, this non-touch SPI display delivers bright, sharp graphics and is ideal for IoT dashboards, sensor readouts, portable instruments and embedded projects.

Key Features

• 2.8 inch diagonal TFT LCD with 240×320 pixel (QVGA) resolution
• ILI9341 display driver for reliable performance and broad library support
• SPI (Serial Peripheral Interface) 4-wire connection: uses minimal I/O pins
• 65K colors (16-bit RGB) and white LED backlight for clear visibility
• Wide viewing angles and compact, lightweight module for handheld devices
• Operating voltage 3.3V to 5V compatible for direct use with common MCUs
• Low power consumption suitable for battery-powered projects
• Mounting holes for secure integration into enclosures or prototypes

Technical Specifications

• Screen Size: 2.8 inches (diagonal)
• Resolution: 240 × 320 pixels (QVGA)
• Display Controller: ILI9341
• Interface: SPI (4-wire)
• Touch Feature: Not available (Non-Touch)
• Color Support: 65K colors (16-bit RGB)
• Operating Voltage: 3.3V – 5V
• Backlight Type: White LED
• Operating Temperature: -20°C to +70°C
• Module Dimensions: Approx. 71 mm × 52 mm × 7 mm

Compatibility and Library Support

This SPI TFT display is compatible with popular microcontrollers and single-board computers, including Arduino, ESP32 and Raspberry Pi. It works with widely used libraries such as Adafruit_ILI9341, TFT_eSPI, and other ILI9341-compatible libraries, enabling fast development of graphical UIs, plots and simple dashboards.

Wiring and Quick Start Tips

• Power: Connect VCC to 3.3V or 5V (module tolerant) and GND to ground.
• SPI Signals: Connect SCK, MOSI, MISO (if used) and CS to your MCU SPI pins.
• Control Pins: Tie the DC (data/command) and RST (reset) pins to MCU GPIOs as required by your chosen library.
• Backlight: If backlight control is exposed, use a PWM-capable pin to dim the LED for power savings.
• Level shifting: Although the module is 3.3V/5V compatible, follow best practices for signal levels on 5V MCUs where necessary.
• Software: Install Adafruit_ILI9341 or TFT_eSPI library, select SPI mode and correct pins in examples, then upload a test graphic or the library demo.

Recommended Applications

• IoT dashboards and on-device data visualization
• Sensor monitoring systems and data loggers
• Arduino and ESP32 hobby and prototyping projects
• Robotics displays and control panels
• Portable instruments, handheld devices and measurement readouts
• Smart home control panels and custom user interfaces

Mounting, Dimensions and Environmental

The module measures approximately 71 mm × 52 mm × 7 mm and includes mounting holes for secure installation in enclosures or prototypes. It operates reliably from -20°C to +70°C, making it suitable for most indoor and many outdoor embedded applications.

Why Choose This 2.8 Inch SPI TFT (ILI9341)

Choose this 2.8 inch SPI TFT non-touch module when you need a compact, low-power, high-quality display without the complexity or cost of touch support. The ILI9341 driver, broad library compatibility and SPI interface simplify integration and firmware development so you can deliver crisp graphical output quickly.

Note: Images are for illustration purposes only.